How to connect the oxygen concentrator?
Prerequisite:
- The oxygen concentrator has been set up following the steps in Setting up the Oxygen Concentrator page
The priming must finish before plugging the oxygen concentrator into the printer.
The oxygen delivery tube connects from the front of the oxygen concentrator to the back of the Envision One.
Firmly insert the open end of the tube into the plastic release ring at the back of the printer.
The concentrator should stay on during printer operation. It can be turned off when the printer is not in use.
When turning the concentrator back on, wait 30 minutes for the oxygen to prime.
Was this article helpful?
Let us know if you liked the article. That’s the only way we can improve.
